LinceCAD DONUT — Donut
Draws filled rings or filled circles.
- Command:
DONUT· Global name:_DONUT· Alias:DO,DOUGHNUT - Ribbon: Home › Draw
- Menu: Draw
Draws donuts (filled rings) or filled circles. You give the two diameters and then as many centers as you want.
Usage
- Enter DONUT (or DO) or click Donut.
- Enter the inside diameter; Enter accepts the one shown.
Specify inside diameter of donut <…>:
- Enter the outside diameter, greater than the inside one.
Specify outside diameter of donut <…>:
- Specify the center of each donut. Press Enter or Esc to finish.
Specify center of donut or <exit>:
Notes
- With an inside diameter of 0 you get a filled circle.
- The diameters (0.5 and 1 at the start) are remembered for the next donut during the session.
- Each donut is a closed polyline of two arcs with a width, as in AutoCAD; it can be changed with PEDIT.